![]() System-view From here we need to enter the VLAN1 interface with the following command. At the command prompt type the following command to enter the system view. Now the switch is back to factory build we will need to set an IP address in order to tftp the FW to the switch, in the lab I'll be setting the IP address on the default vlan which is VLAN1. Display current-configuration You should see that this is now running its default config. Reboot Once the switch has come back up and is sat at the command prompt type the following command to confirm the device has been factory reset. After this we will then reboot the swtich, at the command prompt type the following, press enter then Y then enter again. Reset saved-configuration main This will then wipe the main cconfiguration, confirmation below. From here type the following command then press enter then Y and enter again as shown below. ![]() After pressing enter you should see a similar screen to above. First console on to the switch for this I'll be using SuperPuTTY but other SSH/Telnet clients are available. HP A5500 Factory Reset and Firmware upgrade In the following lab I'll run through a factory reset and firmware upgrade, the swtich I'll be using is a HPE 5500 24-port 4-SFP HI running Comware 7. ![]() › ▄ ▄ ▄ Hp 5500 Switch Firmware Download ▄ ▄ ▄
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |